GoPowerSports

150CC Reverse Cable 61" (External Reverse)

Works on all 150 Series HammerHead and Carter Go Karts with external reverse units. 61" Overall Length Round Ball on Both Ends.

150CC Reverse Cable 61" 2-Pack

This reverse cable works on all Hammerhead 150cc Go-Karts, as well as most Carter and various Chinese Go-Karts with external reverse units. 61" Overall Length Round Ball on Both Ends

Starter Relay (Solenoid)

This Starter Relay works with 150cc Trailmaster, Hammerhead, American Sportworks, and Carter Go Karts.   No returns on this product, if you have questions, please call before ordering.

Throttle Cable, TrailMaster 150/150X 77"

Replacement Cable for TrailMaster Blazer 150/150X and standard TrailMaster 150/150X Go-Karts. 77" overall length. 6.000.034 Hammerhead 6.000.232 TrailMaster 630-0001 Carter 14094 Manco

Ignition Coil, TrailMaster 200cc

Fits all 150cc Go Karts.  20" end to end.   No returns on this product, if you have questions, please call before ordering. 

Ignition Switch 5-Wire (GT)

This Ignition Switch plugs into a 5 wire receiver which located in the wiring harness. Only 3 wires will be used. This switch works on the Hammerhead GT model Go Karts.   Does not work with...

Hydraulic Brake Hose 69", Mid

The Mid Rear Brake Hose 69" is a high-quality replacement brake hose designed to fit most mid-sized vehicles. Measuring 69 inches in length, this brake hose is made from durable materials and is...

Brake / Tail Light 150cc, Rectangular

Common brake light used on many Chinese Karts. Lens: 6" x 1.5" Mounting Bolts: 5-1/8" Center     No returns on this product, if you have questions, please call before ordering...

Trail Master 150 Headlight

TrailMaster Headlight Plastic Grate Over Lens Two Pigtails   No returns on this product, if you have questions, please call before ordering.

HammerHead Headlight, Single Beam

HammerHead Single Beam Headlight Plastic Grate Over Lens Single Pigtail  No returns on this product, if you have questions about it, please call before ordering. 

5/8" ID Sealed Bearing, 1 3/8" OD

Standard sized wheel and jackshaft bearing used on most Go Karts and Mini Bikes. 5/8" Inside Diameter 1-3/8" Outside Diameter Outer Snap Ring (Can be Taken Off)

12T GPS Centrifugal Clutch 3/4" Bore, #35

Quality Aftermarket Centrifugal Clutch. Fits all 3 HP - 7 HP engines with a 3/4" crank. Commonly used on one wheel Go Karts with rear tires that are no larger than 15" tall. For Go Karts...