GoPowerSports

Ignition Switch 5-Wire (GT)

This Ignition Switch plugs into a 5 wire receiver which located in the wiring harness. Only 3 wires will be used. This switch works on the Hammerhead GT model Go Karts.   Does not work with...

Hydraulic Brake Hose 69", Mid

The Mid Rear Brake Hose 69" is a high-quality replacement brake hose designed to fit most mid-sized vehicles. Measuring 69 inches in length, this brake hose is made from durable materials and is...

Brake / Tail Light 150cc, Rectangular

Common brake light used on many Chinese Karts. Lens: 6" x 1.5" Mounting Bolts: 5-1/8" Center     No returns on this product, if you have questions, please call before ordering...

Trail Master 150 Headlight

TrailMaster Headlight Plastic Grate Over Lens Two Pigtails   No returns on this product, if you have questions, please call before ordering.

HammerHead Headlight, Single Beam

HammerHead Single Beam Headlight Plastic Grate Over Lens Single Pigtail  No returns on this product, if you have questions about it, please call before ordering. 

5/8" ID Sealed Bearing, 1 3/8" OD

Standard sized wheel and jackshaft bearing used on most Go Karts and Mini Bikes. 5/8" Inside Diameter 1-3/8" Outside Diameter Outer Snap Ring (Can be Taken Off)

Briggs & Stratton Air Filter

Works on 3 HP - 5 HP Briggs and Stratton Horizontal Engines.  

12T GPS Centrifugal Clutch 3/4" Bore, #35

Quality Aftermarket Centrifugal Clutch. Fits all 3 HP - 7 HP engines with a 3/4" crank. Commonly used on one wheel Go Karts with rear tires that are no larger than 15" tall. For Go Karts...

12T Max-Torque Centrifugal Clutch 3/4" Bore, #35

Max Torque Centrifugal Clutch is made in the USA. 3/4" Bore 12 Tooth Fits with #35 Chain Includes 1-3/16" Key Engages at 2200 RPMs The 12T, 3/4" Bore, Max Torque Centrifugal Clutch,...

Large Fuel Tank (2.25 gallons)

This tank does not come with a Petcock or Fuel Cap. You can use the 150cc Vacuum Operated Petcock or the 250cc Manual Petcock. You can find the Fuel Cap here. Used on...

150/250/300 Steering Ball Joint

The 150/250/300 Steering Ball Joint connects the steering linkage to the steering knuckle, allowing for smooth and precise steering control. This Ball Joint is used on most 150cc/250cc/300cc karts by...

Brake Puck, Manual Caliper

The Brake Puck, Manual Caliper is an essential component of any manual brake system. It is designed to fit securely into the caliper and provide a stable surface for the brake pads to press against,...